Step By Step Guide On Using Glaziers Points

Sometimes you might need to carry out some repairs on your widows and for this reason you need to know how to install glazier points. They are very essential instrument that helps to hold glasses in the windows frame. Without a proper knowledge about what glaziers points are, you might get it wrong during installing a new window. Glazier points are inexpensive; you can get it from London Glaziers. The following information teaches you how to properly install glazier points

Installing glazier points
1. You can install glaziers by removing old glazing from the window frame. Begin at the middle of the panel and work towards the corners. Then add a wood chisel between the putty and the glass.
2. Locate a glazier point that holds the glass in the window frame. You might not need to do this as some may come out when the glazier is taken away
3. Take away any tenacious point from the putty. Or, locate needle pliers to scrape off the points
4. 4. Enclose one glaziers point on each side after the frame has been prepared and replaced in the glass. Give a slight pressure to each point to get it firmly in position.
5. Next, place the glazier’s point about 4 inches covering the glass, and then push each gradually. Make sure that each of the points lies flat against the glass
6. Using the putty knife’s edge, drive each point solidly into the wood. In case the wood is too hard for the wood to penetrate, just knock the point gradually inside the wood. And that is all. The procedure is actually very easy to do.
There is no reason why you should hire London Glaziers for a petty job that involves a simple glazier point installation. However, if for any reason you cannot seem to do it properly, you could invite a friend to help you.